Dji MATRICE 200 SERIES V2 User Manual

Loading ...

MATRICE 200

SERIES V2 User Manual

Flight Test

Takeoff/Landing Procedures

1. Place the aircraft in an open, at area with the battery level indicators facing towards you.

2. Turn on the remote controller, then turn on the Intelligent Flight Battery.

3. Launch DJI Pilot and enter the Camera View.

4. Wait until the Aircraft Status Indicators blink green (GPS) or blink green and blue alternately (RTK,

for the M210 RTK V2 only).

5. If the Intelligent Flight Battery temperature is low, use the self-heating function to heat the

batteries to ensure the temperature is suitable for the aircraft to take off.

6. Turn on the motors using CSC and push the left stick up slowly to take off.

7. To land, hover over a level surface and gently pull down on the left stick to descend.

8. After landing, execute the CSC command or hold the left stick at its lowest position until the

motors stop.

9. Turn off the Intelligent Flight Battery rst, then the remote controller.

It is important to understand basic ight guidelines for the safety of both you and

those around you.

Refer to the Disclaimer and Safety Guidelines for more information.

Only remove the batteries after powering off.

When the Aircraft Status Indicators blink yellow rapidly during ight, the aircraft has entered Failsafe

mode.

A low battery level warning is indicated by the Aircraft Status Indicators blinking red slowly

or rapidly during ight.

Watch our video tutorials for more ight information.

Video Suggestions and Tips

1. Go through the full pre-ight checklist before each ight.

2. Select the desired gimbal operation mode in the DJI Pilot app.

3. Only shoot video when ying in P-mode.

4. Always y in good weather and avoid ying in rain or heavy wind.

5. Choose the camera settings that suit your needs. Settings include photo format and exposure

compensation.

6. Perform ight tests to establish ight routes and preview scenes.

7. Push the control sticks gently to keep the aircraft’s movement smooth and stable.

IP43 Protection Rating

Under stable laboratory conditions, the Matrice 200 Series V2 achieves an IP43 protection rating by

IEC60529 standards when equipped with TB55 Intelligent Flight Batteries. However, this protection

rating is not permanent and may reduce over time after long-term use.

DO NOT y when the amount of rainfall exceeds 10 mm/day.

DO NOT fold the frame arms in the rain.

The angle of inclination of the aircraft body and the ground should not exceed ±30° when y the

aircraft in rainy days.

Loading ...

Dji MATRICE 200 SERIES V2