Loading ...
Loading ...
Loading ...
30
©
2019 DJI All Rights Reserved.
MATRICE 200
SERIES V2 User Manual
LED3 blinks twice per second Over charge detected
LED3 blinks three times per
second
Over-voltage charger detected
LED4 blinks twice per second
Charging temperature is too
low (<0°C)
LED4 blinks three times per
second
Charging temperature is too
high (>40°C)
After any of the above mentioned protection issues are resolved, press the button to turn off the
Battery Level Indicator. Unplug the Intelligent Flight Battery from the charger and plug it back in to
resume charging. Note that you do not need to unplug and plug the charger in the event of a room
temperature error, the charger will resume charging when the temperature falls within the normal
range.
DJI does not take any responsibility for damage caused by third-party chargers.
To ensure safety, discharge the battery before transporting the aircraft. Fly the aircraft out-
doors until its power level is lower than 30%.
The battery has a capacity of 174.6 Wh. Please follow the regulations and guidelines for
traveling with these batteries via air.
Buzzer Beeping Description
Toggle the buzzer switch to turn on/off the warning sound.
Descriptions Beeping Pattern
Toggle the buzzer switch to turn it on Quick beeping
Connect to the Battery Charger Quick beeping
A battery pair is fully charged Quick beeping
Four Intelligent Flight Batteries are fully charged
Alternating between two short and one
long beep, lasting for about 1 hour
Updating the Firmware
DJI will release rmware updates when available. Refer to the ofcial DJI website and follow the
instructions below to update the rmware.
1. Download the latest rmware update program from the ofcial DJI website.
(http://www.dji.com/matrice-200-series-v2/info#downloads)
2. Turn on the Charging Hub, then connect it to a computer using a Micro USB cable.
Loading ...
Loading ...
Loading ...