Loading ...
Loading ...
Loading ...
Chapter 5 Network Tab
Secondary
Connection
If your ISP provides an extra Connection type such as Dynamic/Static IP to
connect to a local area network, you can activate this secondary
connection.
Disable - The Secondary Connection is disabled by default, so there is
PPPoE connection only. This is recommended.
Dynamic IP - Use dynamic IP address to connect to the
local area
network provided by ISP.
Static IP - Use static IP address to connect to the local area network
provided by ISP.
MTU Size The default MTU (Maximum Transmission Unit) size is 1480 bytes, which is
usually appropriate. For some ISPs, you need modify the MTU. This should
not be done unless your ISP told you to.
Service Name/AC
Name
Do not change it unless your ISP told you to.
Detect Interval The default value is 0. You can input the value between 0 and 120. The
device will detect Access Concentrator online every interval seconds. If
the value is 0, it means not detecting.
Use ISP-Specified IP If your service provider give you an IP address along with the user name
and password, Enable "Use ISP-specified IP" and enter the IP address,
which is provided by your ISP.
Use These DNS
Servers
If the ISP specifies a DNS server IP address for you, Enable
Use These
DNS Server
, and fill the
Primary DNS
and
Secondary DNS
fields below.
Otherwise, the DNS servers will obtain automatically from ISP.
WAN MAC Address This field displays the current MAC address of the WAN port. If your ISP
binds the MAC address of your previous computer/router,
enter the
correct MAC address into this field. The format for the MAC Address is XX-
XX-XX-XX-XX-XX (X is any hexadecimal digit). Click Restore Factory MAC
to restore the MAC address of WAN port to the factory default value.
Your PC’s MAC
Address
This field displays the MAC address of the PC that is managing the router.
You can click Clone PC’s MAC to set the WAN MAC address the same as
your management PC’s MAC.
Click Connect to connect immediately. Click Disconnect to disconnect immediately. You can
check and control the status of WAN connection on Monitor > Dynamic WAN
page.
L2TP/PPTP
The configuration steps of these two WAN connections are the same. Take L2TP as an example
to introduce.
-
48 -
Loading ...
Loading ...
Loading ...