Loading ...
Loading ...
Loading ...
34 English
Maintenance
Maintenance
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm
soapy water. Then, scour impurities off of the racks using a plastic scouring pad.
If the racks do not slide in and out smoothly after you have cleaned them, rub the
side rail guides with wax paper or a cloth containing a few drops of cooking oil.
This will help the racks glide more easily on their tracks.
Gliding rack
1. Remove the gliding rack from the oven.
2. Fully extend the gliding rack on a table.
It is a good idea to put newspaper
beneath the rack for later cleanup.
3. If the sliding tracks are soiled, remove
dirt and grime using a paper towel.
Reapply the graphite lubricant
according to the instructions below:
To apply the graphite lubricant
1. Shake the graphite lubricant before
opening it.
2. Apply 4 drops of lubricant to the
inner side of the left sliding track, and
4 drops to the outer side of the left
sliding track.
3. Repeat step 2 above on the right sliding
track.
Maintenance
Cleaning
Control panel
First, lock the control panel and the door to prevent accidental operations and/or
product tipping.
1. Press and hold the OFF/CLEAR button for 3 seconds to lock both the control
panel and the door.
2. Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3. When done, press and hold the OFF/CLEAR button again for 3 seconds.
WARNING
• Make sure the control panel turns off and all surfaces of the gas oven are cool
before cleaning. Otherwise, you can get burned.
• If the gas oven has been moved away from the wall, make sure the anti-tip
device is reinstalled properly when the gas oven has been put into place
again. Otherwise, the gas oven may tip over, causing physical injuries.
• Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1. Remove any spills, spots, and grease stains using a soft, wet cloth.
2. Apply an approved stainless steel cleanser to a cloth or paper towel.
3. Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4. When done, dry the surface using a soft, dry cloth.
5. Repeat steps 2 through 4 as many times as necessary.
CAUTION
• Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
• Do not spray any type of cleanser into the manifold holes. The ignition system
is located in those holes and must be kept free of moisture.
NX58J7750S_AA_AC_DG68-00623A-07_EN+CFR.indb 34 2018-08-30 12:22:03
Loading ...
Loading ...
Loading ...