Loading ...
Loading ...
Loading ...
AXIS P3364–VE
Hardware Overview
NOTICE
Due to local regulations or the environmental and electrical conditions in which the p roduct is to be used, a shielded
network cable (STP) may be appropriate or req uired. Any network cab les that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
Electromagnetic Compatibility (EM C )
for regulatory requirements.
Audio in (pink) - 3.5 mm input for a m ono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or a n active speaker
with a built-in amplifier. A stereo connector must be used for audio out.
SD card slot - A standard or h igh-capacity SD card (not included) can be used for local recording with removable storage.
NOTICE
To p revent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card a n d click Unmount.
Control button - The control button is used for:
• ConnectingtoanAXISVideoHostingSystemservice.See
page 42
. To connect, press and hold the button for about
1 second until the Status LE D flashes gr een .
• ConnectingtoAXISInternetDynamicDNSService. See
page 43
. To connect, press and hold the button for
about 3 seconds.
• Resetting the p rod uct to fa ctory default settings. See
page 49
.
I/O terminal connector - Use in applications for e.g. m otion detection, event triggering, time lapse r ecording and alarm notifications.
In addition to an auxili ary pow e r and a GND pin, the I/O terminal connector pro v ides the interface to:
• Digital output — For connecting externa l devices such as relays and LEDs. Connected devices can be activated by
the VAPIX® Application Programming Interface, output b uttons on the Live View page or by an Actio n Rule. The
output will show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input — An alarm input for connecting devices that can toggle between an open a nd closed circuit, for
example: PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state chan ges and
the input becomes active (shown under System Options > Ports & Devices).
LED Indicators
LED
Color
Indication
Green
Steady for connection to a 100 MBit/s network. Flashes for network activity.
Amber
Steady for connection to a 10 MBit/s network. Flashes for network activity.
Network
Unlit No network connecti
on.
Green Steady g reen for normal operation.
Amber
Steady during startup and when restoring settings.
Status
Red
Sl
ow flash for failed upgrade.
Green
Normal operation.
Power
Amber
Flashes green/amber during firmware upgrade.
5
Loading ...
Loading ...
Loading ...