Loading ...
Loading ...
Loading ...
RIGOL Chapter 2 To Set the Vertical System
2-2 MSO2000A/DS2000A User’s Guide
To Enable the Analog Channel
MSO2000A/DS2000A provides 2 analog input channels (CH1 and CH2) and provides
independent vertical control system for each channel. As the setting methods of the
vertical systems of the two channels are the same, this chapter takes CH1 as an
example to illustrate the setting method of the vertical system.
Connect a signal to the input connector of CH1 and then press CH1 in the vertical
control area (VERTICAL) at the front panel to enable CH1.
At this point, the channel setting menu is displayed at the right side of the screen and
the channel status label at the bottom of the screen (as shown in the figure below) is
highlighted. The information displayed in the channel status label is related to the
current channel setting.
After the channel is turned on, modify the parameters such as the vertical scale,
horizontal time base and trigger mode according to the input signal to make the
waveform display easy to be observed and measured.
Loading ...
Loading ...
Loading ...