Loading ...
Loading ...
Loading ...
INSTALLATION - 7191477A521/A
e
side panel of the compartment.
To refit the rack/tray support frames:
• Position the frame on the side panel of the
compartment and screw the fastening pins
into place.
Special cleaning functions
• From position 0, turn the function knob to the
left by one position. The button flashes.
Automatic cleaning
1. Touch the button in the "main menu" (in
the lower area ).
2. Open the door.
3. Press the START button to start the
automatic cleaning.
4. At the end of the automatic cleaning, dry the
inside of the appliance thoroughly.
5. Close the door.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
INSTALLATION
Electrical connection
General information
Check the mains characteristics against the data
indicated on the plate.
The identification plate bearing the technical
data, serial number and brand name is visibly
positioned on the appliance.
Do not remove this plate for any reason.
The appliance must be connected to ground
using a wire that is at least 20 mm longer than
the other wires.
The appliance can work in the following modes:
• 220-240 V~
3 x 1.5 mm² three-core cable.
Fixed connection
Fit the power line with an all-pole circuit breaker
Hold the frame firmly with one hand to
prevent it from falling and damaging the
surfaces of the appliance.
The automatic cleaning function has the
task of sanitising the inside of the cavity
from unpleasant odours generated
during operation.
Automatic cleaning does not start if the
door is closed.
If the door is accidentally closed during
the function, the appliance interrupts the
function while waiting for the door to
reopen.
See General safety instructions.
The values indicated above refer to the
cross section of the internal lead.
The aforementioned power cables are
sized taking into account the
coincidence factor (in compliance with
standard EN 60335-2-6).
Loading ...
Loading ...