Loading ...
Loading ...
Loading ...
(RefertoConnectingtoaComputer)
P_oberos iterated to _ll'_eScreen
[] Note
• Problems related to the LCD Display screen and their solutions are listed
Problems
The screen is blank and the power
ind cator s off.
'Check Signa_ CaMe" message.
"Not Opt mum Mode _ message.
The p cture roils vertically,
The image is not dear; picture s
Marred.
The p eture image is unstable and
shakes.
Ghost images are shown in the
picture.
The image s too light or too dark.
The screen color is inconsistent.
The coot image is distorted by
dark shadows.
The eoor whte is poor.
The power Indicator blinks green
The screen is blank and the power
indicator _ight is steady green or
blinks every 05 or I seconds.
The screen is blank and it s
blinking.
Solutions
Ensure that the power cord is firmly connected and the LCD
LCD Display is on.
(Refer to the Connecting the LCD Display )
Ensure that the signal cable is firmly connected to the PC or
video sources
(Refer to the Connecting the LCD Display )
Ensure that the PC or video sources ere turned on.
Check the maximum resolution end the frequency of the video
Adaptor.
Compare these values with the data in the Preset Timing Modes
Chart.
Check if the signal cable is securely connected.
Re-connect it, if necessary.
(Refer to Connecting to a Computer)
Run Frequency Coarse end Fine tuning.
® Turn on again after removing all accessories
(video extension cable, etc)
® Set the resolution end frequency to the recommended ranges.
Check if the resolution and frequency set for the computer video
card falls in the range supported by the LCD Display
If not, reset them referring to the current Information under the
LCD Display menu and Preset Timing Modes
Adjusts the brightness and contrast.
(Refer to the Brightness. Contrast)
Adjust color using Custom under OSD Color Adjustment menu
® The LCD Display is currently saving the changes made to the
settings to the OSD memory.
The LCD Display is using its power management system.
® Press a key on the keyboard
If you see the "TEST GOOD" message on the screen when you
pressing the MENU button, check the cable connection between
the LCD Display end the computer to ensure that the connector
is properly connected
: P_obems ,e a_ed to Audo
[] Note
Loading ...
Loading ...
Loading ...