Loading ...
Loading ...
Loading ...
Fuses and bulbs
Several warning and control lamps light up
f
or a f
ew sec
onds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
Checking the bulbs of a trailer
For vehicles with the factory fitted towing
bracket, certain trailer lights are also control-
led if the power socket is correctly connected.
A fault on a trailer turn signal is indicated on
the instrument panel by the turn signal blink-
ing twice as fast ( or ) ››› page 130.
●
General fault of all turn signals on one side.
●
Fault in one rear light (on some models, al-
so the registration light).
●
Fault in two brake lights.
WARNING
Observe the safety warnings ›››
in Control
and warning l
amps on page 107.
Note
A fault in the LED on the rear lights will not be
indicated. Ho
wever, if the fault affects all the
LEDs then this will be indicated by the control
lamp .
To replace halogen headlight bulbs
Fig. 104 In the engine compartment: left-
h
and s
ide he
adlight lining.
A
dipped beam
he
a
dlights,
B
daytime driving lights and
C
main beam headlights and side lights
Fig. 105 Left headlight.
There is no need to remove the headlight to
r
ep
l
ace bulbs.
Complete operations only in the sequence
given:
Turn signals (small bulb holder)
1. Open the bonnet
››› page 271.
2. Rotate the bulb holder
1
to the left all the way
and pull it out backwards together with the bulb.
3. Depending on the model, the bulb is removed di-
rectly from the bulb holder or it may need to be ro-
tated and then removed.
4. Replace the faulty bulb with a new identical bulb.
5. Place the bulb holder in the headlight and rotate
to the right all the way.
Dipped beam
A
and daytime lights
B
1. Open the bonnet
››› page 271.
2. Remove the rubber cover on the rear of the head-
light.
3. Rotate the bulb holder to the left all the way and
pull it out backwards together with the bulb.
4. Depending on the model, the bulb is removed di-
rectly from the bulb holder or it may need to be ro-
tated and then removed.
5. Replace the faulty bulb with a new identical bulb.
6. Place the bulb holder in the headlight and rotate
to the right all the way.
7. Insert the rubber cover.
»
93
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...