Loading ...
Loading ...
Loading ...
Seats and head restraints
backrests are tilted to the rear, the greater
the risk of
injury due to improper positioning
of the belt web!
●
Exercise caution when securing the seat
height into forwards/backwards position. In-
juries can be caused if the seat height is ad-
justed without due care and attention.
●
To move the seat forwards and backwards,
pull upwards and not sideways on the lever,
as the force exerted on it in that direction
could damage it.
Adjusting the front head restraints
Read the additional information carefully
›
›
›
page 19
Adjust the head restraint ›››
page 19 so
that as far as possible the top of the head re-
straint is level with the top of your head.
When this is not possible, try to get as close
as possible to this position.
WARNING
●
Never drive if
the head restraints have been
removed. Risk of injury.
●
After refitting the head restraint, you must
always adjust it properly for height to achieve
optimal protection.
●
Please observe the safety warnings ›››
in
Correct
adjustment of front head restraints on
page 79.
Note
●
When fitting the hea
d restraints again, in-
sert the tubes as far as possible into the
guides without pressing the button.
Adjustment of the rear head restraints
Fig. 155 Rear centre head restraint: release
point
.
When transporting people in the back seat,
p
l
ac
e the head restraints of the occupied
seats at a minimum of the next socket up
›››
.
Adju
s
tin
g the head restraints
–
To set the head restraint higher, grasp the
sides with both hands and move it up-
wards, until you see it engage.
–
To set the head restraint lower down, press
the ››› Fig. 155
1
button and move it
do
wn
w
ards.
Removing the head restraint
To remove the head restraint, the correspond-
ing backrest must be partially folded forward.
–
Unlock the backrest ››› page 157.
–
Move the head restraint upwards until it ar-
rives to the top.
–
Press button
1
, while simultaneously
pr
e
s
sing on the security hole
2
with a flat
s
c
r
ewdriver a maximum of 5 mm wide, and
remove the head restraint.
–
Move the backrest until it engages properly
›››
.
Fittin
g the he
a
d restraint
To mount the external head restraints, the
corresponding backrest must be partially fol-
ded forward.
–
Unlock the backrest ››› page 157.
–
Insert the head restraint bars into the
guides until they perceptibly engage. It
should not be possible to remove the head
restraint from the backrest.
–
Move the backrest until it engages properly
›››
.
»
155
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...