Loading ...
Loading ...
Loading ...
Fuses and bulbs
CAUTION
●
Remov
e the ignition key before working on
the electric system. Otherwise, a short circuit
could occur.
●
Switch off the lights or parking lights be-
fore you change a bulb.
For the sake of the environment
Please ask your specialist retailer how to dis-
pose of u
sed bulbs in the proper manner.
Note
●
Depending on w
eather conditions (cold or
wet), the front lights, the fog lights, the tail
lights and the turn signals may be temporari-
ly misted. This has no influence on the useful
life of the lighting system. By switching on
the lights, the area through which the beam
of light is projected will quickly be demisted.
However, the edges may continue to be mis-
ted.
●
Please check at regular intervals that all
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
not only in the interest of your own safety,
but also that of all other road users.
●
Before changing a bulb, make sure you
have the correct new bulb.
●
Do not touch the glass part of the bulb with
your bare hands, use a cloth or paper towel
instead. The residue left by the fingerprints
would vaporise as a result of the heat gener-
ated by the bulb, they will be deposited on
the reflect
or and will impair its surface.
●
Depending on the level of equipment fitted
in the vehicle, LEDs may be used for part or
all of the interior and/or exterior lighting.
LEDs have an estimated life that exceeds than
that of the car. If an LED light fails, go to an
authorised workshop for its replacement.
Halogen headlights.
Pos
ition of the bulbs
Fig. 112 Halogen headlights.
Turn signal
M
ain be
am he
adlights
Dipped beam headlights
DRL (daytime running light)/side light
A
B
C
D
Main beam headlights
Fig. 113 In the engine compartment: main
be
am he
a
dlight bulb.
–
Raise the bonnet.
–
Turn the cover
1
anti-clockwise and take it
out
›
›
› Fig. 113.
–
Remove the bulb connector
2
by pulling it
outw
ar
d
s.
–
Remove the bulb by pulling it out and fit
the new one.
–
Fit the bulb connector
2
.
–
Fit cover
1
, turning it towards the right.
–
Check whether the new bulb is working.
107
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...