Loading ...
Loading ...
Loading ...
#
Press and hold button 1, 2 or 3 that you
wish to program.
Indicator lamp 4 f lashes yellow.
%
It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
#
Release the previously pressed button.
Indicator lamp 4 continues to flash yellow.
#
Point remote control 5 from a distance of
1 in (1 cm) to 3 in (8 cm) towards buttons
1, 2 or 3.
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green contin‐
uously. Programming is complete.
R
Indicator lamp 4 f lashes green. Pro‐
gramming was successful. Additionally,
synchronization of the rolling code with
the door system must also be car ried out.
#
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
#
Release all of the buttons.
%
The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronizing the rolling code
Requirements:
R
The door system uses a rolling code.
R
The vehicle must be within range of the
garage door or door drive.
R
The vehicle as well as persons and objects,
are located outside the range of movement
of the door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1, 2
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
150
Driving and parking
Loading ...
Loading ...
Loading ...