Loading ...
Loading ...
Loading ...
4
85
ACCESS
Starting the vehicle
) Insert the key in the ignition switch.
The system recognises the starting
code.
) Turn the key fully towards the dash-
board to position 3 (Starting) .
) When the engine starts, release the
key.
Switching the vehicle off
) Immobilise the vehicle.
) Turn the key fully towards you to po-
sition 1 (Stop) .
) Remove the key from the ignition
switch.
Remote control problem
Following disconnection of the vehicle
battery, replacement of the remote con-
trol battery or in the event of a remote
control malfunction, you can no longer
unlock, lock or locate your vehicle.
) First of all, use the key in the lock to
unlock or lock your vehicle.
) Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.
Changing the battery
Battery ref.: CR1620 / 3 volts.
Reinitialisation
) Switch off the ignition.
)
Turn the key to position 2 (Ignition on) .
) Press the closed padlock immedi-
ately for a few seconds.
) Switch off the ignition and remove
the key from the ignition switch.
The remote control is fully operational
again.
If the battery is fl at, you are in-
formed by illumination of this
warning lamp, an audible signal
and a message in the multi-
function screen.
Key left in the "Ignition on"
position
On opening the driver's door, an
alert message is displayed, accom-
panied by an audible signal, to re-
mind you that the key is still in the
ignition switch at position 1 (Stop) .
If the key has been left in the igni-
tion switch at position 2 (Ignition
on) , the ignition will be switched off
automatically after one hour.
To switch the ignition back on, turn
the key to position 1 (Stop) , then
back to position 2 (Ignition on) .
) Unclip the casing using a coin at the
notch.
) Slide the fl at battery out of its location.
) Slide the new battery into its loca-
tion observing the original direction.
) Clip the casing.
) Reinitialise the remote control.
A heavy object (key fob...), attached
to the key and weighing down on
its shaft in the ignition switch, could
cause a malfunction.
Loading ...
Loading ...
Loading ...