Loading ...
Loading ...
Loading ...
(Continued)
• The battery may rupture or ex‐
plode
when you jump start with a
low or frozen battery.
Jump starting procedure
NOTICE
Your vehicle has a battery in the
trunk room, but when you jump
start your vehicle, use the jumper
terminal in the engine room.
1. Make sure the booster battery is
12-volt and that its negative termi‐
nal is grounded.
2. If the booster battery is in another
vehicle, do not allow the vehicles to
touch.
3. Turn off all unnecessary electrical
loads.
4. Open the engine hood.
5. Lift the end of strip (5) up.
6. Press the fastener head with screw
driver and then pull the fastener
out.
7. Lift the rear portion of small serv‐
ice cover (6) up and then remove
the service cover.
(A) : for assemble, (B) : for remove
8. Press the fastener head with screw
driver and then pull the fastener
out from main service cover (7).
9. Pull the main service cover over
7 mm to toward the front of the
vehicle.
10. Lift the main service cover up and
then remove the main service cov‐
er. Be careful not to damage the
holder under the main service cov‐
er.
11. Connect the jumper cables in the
exact sequence shown in the illus‐
tration. First connect one end of a
jumper cable to the positive termi‐
nal of the jump start connector (1),
What to do in an emergency
6-06
Loading ...
Loading ...
Loading ...