Loading ...
Loading ...
Loading ...
Tire Puncture u Removing Wheels
196
Troubleshooting
5.
Install and tighten the axle bolt.
6.
Loosen the right axle pinch bolts.
7.
Tighten the left axle pinch bolts.
8.
Install the right brake caliper and
tighten the mounting bolts.
9.
Install the left brake caliper and tighten
the mounting bolts.
u Take care to prevent the brake
caliper from scratching the wheel
during installation.
u Use new mounting bolts when
installing the brake caliper.
10.
Install the wheel speed sensor and
tighten the bolt securely.
11.
Lower the front wheel on the ground.
12.
Apply the brake lever and pedal several
times. Then, pump the fork several
times.
13.
Make sure the end of the front axle
shaft align with the surface of the right
fork leg.
Retighten the right axle pinch bolts.
14.
Raise the front wheel off the ground
again, and check that the wheel
rotates freely after you release the
brake.
15.
Uncover the protective tape or cloth.
16.
Install the front fender A and tighten
the bolts securely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Torque: 44 lbf·ft (59 N·m, 6.0 kgf·m)
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m)
Surface of
fork leg
End of front
axle shaft
Torque:
31 lbf·ft (42.5 N·m, 4.3 kgf·m)
Torque:
31 lbf·ft (42.5 N·m, 4.3 kgf·m)
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the pads
to avoid scratching them.
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m)
Loading ...
Loading ...
Loading ...