Loading ...
Loading ...
Loading ...
SDS1000X-E&SDS1000X-U User Manual
109
WWW.SIGLENT.COM
UART Serial Decode
After completing the setup of UART signal and trigger, we will decode UART signals.
Operation steps as follows.
1. Press Decode → Decode. Select one of the options from the Decode1 and
Decode2.
2. Press the Display and select On to display the result of decoding.
3. Press the Configure to set the baud rate, data length, parity check, stop bit, idle
level and bit order. Refer to “Setup for UART Signals” to set parameters.
4. Press the List to enter the LIST function menu.
Press the Display and choose the same options as the first step.
Press the Scroll and turn the Universal Knob to view all frames.
Press the Lines and set the number of lines by Universal Knob. The range
of the lines is 1 to 7.
Users can export the result list of the package to the external USB storage
device in csv format (only when the USB flash disk is detected). Saving the
data (*.csv) is similar to the operation of setup files, see the section
"External save and recall" for details.
5. Press the Format to change the character encoding format of the decoding’s
result.
6. Press the Copy Setting to enter the COPY function menu to synchronize the
corresponding bus configuration and trigger configuration.
7. Press the Tips Info to turn on or off the decoding limit prompt. When the
decoding frame number reaches the maximum, it will pop up "Decoding to
maximum frame number limitation!"
Figure 58 UART Decode
Loading ...
Loading ...
Loading ...