Loading ...
Loading ...
Loading ...
Select the outgoing half of an edit point (the left side), then Command-click to select the incoming
half of the same edit point (the right side) separately. This will not perform a roll edit, but will allow
you to either use the Selection tool to resize both edit points away from each other to create a
gap, or use the Trim tool to ripple both sides of the edit to shorten both clips while tightening up
the Timeline at the same time.
Before and After ripple trimming both the incoming and outgoing halves
of an edit to shorten the duration of both clips at once
You can also select the In and Out points of a clip in the Timeline at the same time, and use the
Trim tool to ripple both the beginning and end of the clip closer to the center, shortening the clip
while preserving the content in the middle, while tightening up the Timeline.
Before and After ripple trimming both the In and Out points of a clip at the same time, shortening
the clip by removing heads and tails, and preserving the action in the middle
Chapter 43Trimming 735
Loading ...
Loading ...
Loading ...