Loading ...
Loading ...
Loading ...
(414,1)
410 In case of emergency
MWAG0123X
WARNING
Always follow the instructions below. Failure to
do so could result in damage to the charging
system and cause personal injury.
1. If the booster battery is in another vehicle
,
position the two vehicles (
and ) to bring
their batteries into close proximity to each
other.
Do not allow the two vehicles to touch.
2. Apply the parking brake.
3. Push the park button to engage the P (Park)
position.
4. Switch off all unnecessary electrical systems
(headlights, heater, air conditioner, etc.).
5. Connect jumper cables in the sequence as
illustrated (
? ? ? ).
CAUTION
* Always connect positive (+) to positive (+)
and negative (−) to body ground (for
example, as illustrated), not to the battery.
* Make sure the jumper cables do not touch
moving parts in the engine compartment
and that the cable clamps do not contact
any other metal.
6. Start the engine of the booster vehicle
and
let it run for a few minutes.
7. Keep the engine speed of the booster vehicle
at about 2,000 rpm, and start the engine of
the vehicle
being jump started.
CAUTION
Do not keep the starter motor engaged for
more than 10 seconds. If the engine does not
start right away, place the ignition switch in
the “OFF” position and wait 10 seconds before
trying again.
8. After starting your engine, carefully disconnect
the negative cable and then the positive cable
(
? ? ? ).
NOTE:
Use the special 12-volt battery (main battery)
that is enhanced in regard to the charge-
discharge capacity and life performance. Avoid
Loading ...
Loading ...
Loading ...