Loading ...
Loading ...
Loading ...
(313,1)
The radar sensors may be blocked by temporary
ambient conditions such as splashing water, mist
or fog.
The blocked condition may also be caused by
objects such as ice, frost or dirt obstructing the
radar sensors.
Check for and remove objects obstructing the area
around the radar sensors.
Do not attach stickers (including transparent
material), install accessories or apply additional
paint near the radar sensors.
Do not strike or damage the area around the radar
sensors. It is recommended that you visit a NISSAN
dealer or qualified workshop if the area around the
radar sensors is damaged due to a collision.
Precautions on repairing the bumper
MEVT33A1-953DA44C-2DBE-45FC-9637-093705C40D8D
When repairing the bumper, take cautious because
the radar sensors are installed on the bumper. For
more details, see “Precautions on repairing the
bumper” (P.294).
MEVT33A1-131C307F-FF63-48FD-A763-1DAB78A699E4
The speed limiter allows you to set the desired
vehicle speed limit. While the speed limiter is
activated, the driver can perform normal braking
and acceleration, but the vehicle will not exceed
the set speed.
WARNING
* Always observe posted speed limits. Do
not set the speed over them.
* Always confirm the setting status of the
speed limiter on the vehicle information
display.
When the speed limiter is on, the cruise control
(where fitted) system cannot be operated.
SPEED LIMITER OPERATIONS
MEVT33A1-07A8ACF4-40B8-4068-BBE9-52A63E3A6097
The speed limiter can be set at a speed between
the following speeds.
* 30 to 200 km/h (20 to 125 MPH)
MWAF1178X
The speed limiter set switches are located on the
steering wheel.
1. <RES+> switch
2. <SET-> switch
3. <CANCEL> switch
4. Speed limiter MAIN switch (When this switch
is pushed, the speed limiter enters the
standby mode. If the cruise control (where
fitted) or ICC system (where fitted) is on, the
system will turn off and the speed limiter
enters the standby mode.)
MJVS0284X
The speed limiter operating condition is shown on
the vehicle information display.
1. Speed limiter indicator
2. Set speed indicator
The speed unit can be converted between [km/h]
and [MPH]. (See “[Unit/Language]” (P.89).)
When the vehicle speed exceeds the set speed
limit, the set speed indicator blinks and the
accelerator pedal operation will not work until
the vehicle speed slows down to the set speed
limit.
Starting and driving 309
SPEED LIMITER (where fitted)
SPEED LIMITER (where fitted)
Loading ...
Loading ...
Loading ...