Nissan 2023 X-TRAIL

User Manual - Page 123

For 2023 X-TRAIL.

PDF File Manual, 486 pages, Read Online | Download pdf file

2023 X-TRAIL photo
Loading ...
Loading ...
Loading ...
(121,1)
lever to any position other than high speed.
Push the lever up
to have one sweep operation
of the wiper.
Pull the lever toward you
to operate the washer.
Then the wiper will also operate several times.
The headlight cleaner (where fitted) will also
operate with operation of the windscreen washer.
(See “Headlight cleaner (where fitted)” (P.117).)
NOTE:
The Speed Dependent feature may be disabled.
For additional information, refer to “[Vehicle
Settings]” (P.86).
Headlight cleaner (where fitted)
MEVT33A1-31E21B37-5355-4A2B-8D5A-FBE393594AD9
Pull the lever toward the rear of the vehicle .
The headlight cleaner will operate with operation
of the windscreen washer.
* The headlight cleaner operates with the wind-
screen washer operation. This operation acti-
vates once each time the ignition switch is
turned off and on.
* After the first operation, the headlight cleaner
operates once at every fifth operation of the
windscreen washer.
CAUTION
Add the window washer fluid reservoir when
the fluid is at a low level.
RAIN-SENSING AUTO WIPER SYSTEM
MEVT33A1-C3DA0905-9EBF-4814-8E98-41180361A122
MWBC0049X
The rain-sensing auto wiper system can automa-
tically turn on the wipers and adjust the wiper
speed depending on the rainfall and the vehicle
speed by using the rain sensor located on the
upper part of the windscreen.
To set the rain-sensing auto wiper system, push
the lever down to the “AUTO” position
. The wiper
will sweep once while the ignition switch is in the
ON position.
The rain sensor sensitivity level can be adjusted by
turning the knob toward
(Low) or (High).
* High High sensitive operation
* Low Low sensitive operation
To turn the rain-sensing auto wiper system off,
push up the lever to the “OFF” position, or pull
down the lever to the other.
CAUTION
Do not touch the rain sensor and around it
when the wiper switch is in the “AUTO” position
and the ignition switch is in the ON position.
The wipers may operate unexpectedly and
cause an injury or may damage a wiper.
* The rain-sensing auto wipers are intended
for use during rain. If the switch is left in
the “AUTO” position, the wipers may oper-
ate unexpectedly when dirt, fingerprints,
oil film or insects are stuck on or around
the sensor. The wipers may also operate
when exhaust gas or moisture affect the
rain sensor.
* When the windscreen glass is coated with
water repellent, the speed of the rain-
sensing auto wipers may be higher even
though the amount of the rainfall is small.
* Be sure to turn off the rain-sensing auto
wiper system when you use a car wash.
* The rain-sensing auto wipers may not
operate if rain does not hit the rain sensor
even if it is raining.
* Using genuine wiper blades is recom-
mended for proper operation of the rain-
sensing auto wiper system. (See “Wind-
screen wiper blades” (P.436) for wiper
blade replacement.)
Instruments and controls 117
Loading ...
Loading ...
Loading ...