Loading ...
Loading ...
Loading ...
2.Placesawonlegssothatholesinbottonofsaw
lineupwithholesin topoflegs.
3.Installscrews,washers,Iockwashersandnuts
asshown.
Ifyoumountthesawonanyotherbench,makesure
thatthereisanopeninginthetopofthebenchthe
samesizeastheopeninginthebottomofthesawso
thatthesawdustcandropthrough.Recommended
workingheightis33to37inchesfromthetopofthe
sawtabletothe floor.
SAW eASE _[
FLAT WASHER -----_
I "J
END
STIFFENER- _1
FLATWASHER----", _, ]l
H
13
®
2-3/4
7/16 DIA. HOLES
16
13
I FRONT OF SAW _
NOTE: All dimensions in inches
1/2
CHECKING TABLE INSERT
1. Insert should be flush with table top along its
entire length. Check as shown. Loosen flat head
screw that holds insert and adjust the four set
screws asnecessary. Tighten flat head screw. Do
not tighten screw to the point where itdeflects the
insert.
F_ 3/32 IN
"_ SETSCREW WRENCH
2. To remove insert.
A) Loosen Screw
B) Lift insert from end, and pull toward front of
saw.
3. TO replace insert.
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten
screw.
Do not tighten screw to the point where it will
deflect the insert.
9
Loading ...
Loading ...
Loading ...