Loading ...
Loading ...
Loading ...
NEVER OPERATE THE SAW WITHOUT THE
PROPER INSERT iN PLACE. USE THE SAW
BLADE iNSERT WHEN SAWING . . . USE THE
COMBINATION DADO_MOLDING INSERT
WHEN DADOING OR MOLDING.
10. REMOVING AND iNSTALLING SAWBLADE
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROi_
POWER SOURCE OUTLET BEFORE
REMOVING OR _NSTALLBNG SAWBLADE.
NOTE: If blade is above table when plug is
removed from power source, itwill be necessary
to recalibrate the electronic function. See page
28.
A. Raise Blade Guard ... remove insert.
B. To REMOVE blade, place a block of wood
against frontof blade... PULL arborwrench
toward you to LOOSEN arbor nut.
WOOD BLOCK
OR NUT
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
C. To TIGHTEN arbor nut, place a block of wood
against rear of blade... PUSH wrench away
from you.
When installing the blade.., make sure the
teeth are pointing toward the front of the
saw.., and that the blade and collars are clean,
and free from any burrs.
The HOLLOW side of the collar must be against
the blade.
Always tighten the arbor nut securely.
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
OR NUT
LOOSE
COLLAR
ARBOR __.,. \
TEET.PO,.T,.GTO
FRONT OF SAW %_ .
NUT
NOTE:When using the Dado or Molding Head, it is
not necessary to install the loose collar. Refer to
instruction sheet packed with dado or molding
head.
To replace insert.
Place insert into insert opening in table and
push toward rear of saw to engage spring clip
and until keyslot in insert will drop over screw.
Tighten screw.
Do not tighten screw to the point where it will
deflect the insert.
11. EXACT-I-CUT
The "'yellow" plastic disc imbedded in the table
in front of the sawblade, is provided for marking
the location of the "sawcut" on the workpiece.
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
A. Check disc ... if it is above table surface,
place a piece of hardwood on top of it and tap
it down.
B. With blade 90 ° (square to table) cut off a
piece of wood.
C. Pull miter gauge back until wood is over disc.
Using very sharp pencil, mark a line on disc.
D. With miter gauge in right hand groove, follow
same procedure and mark another line on
disc.
E. These lines indicate the "'path" of the cut
(kerf) made by the sawblade.
F. When cutting the workpiece, line up mark on
workpiece with line on disc.
2/
Loading ...
Loading ...
Loading ...