Loading ...
Loading ...
Loading ...
8.Holdrodwithonehandandwitha1/2in.wrench
orpliersstartscrewingonONEofthenutsonly
A TURNORTWO, . . screwonothernutthe
sameway.
9. Using TWO 1/2 in. wrenches or pliers tighten
both of the nuts.
10. Slide the bars so that screws are in the MIDDLE
of the slotted holes.
11. Position rip fence over miter gauge groove,
holding up the rear end while engaging front
end with bar.., lower fence onto table.
12. Plug saw into power outlet.
13. Insert yellow key into MASTER switch and turn
on.
14. Press _ key. A "E " will be displayed.
15. Press and hold jog key _ to raise sawblade
about 3 inches above table surface. Release key.
NOTE: Display will not show elevation or angle
until saw is "calibrated". This is described after
assembly is complete.
16. Press _ key.
IMASTER_SAW MOTOR
l_To LOCK
REMOV_
YELLOW
KEY
IIIII PULL)NR n
I
YELLOW JOG
KEY KEYS
MINUS
ELEVATION BEd/EL
KEY KEY
17:Place a square against the blade. Make sure
square is not touching the TIP of one of the saw
TEETH.
Press and release _ and
18.
keys
to
bring blade square with table.
19. Turn switch off and remove yellow key.
20. Remove plug from power source.
MAKE SURE SQUARE
IS NOT TOUCHING
TiP OF TOOTH
O
13
Loading ...
Loading ...
Loading ...