Loading ...
Loading ...
Loading ...
MOUNTING THE MOTOR
1. From among the loose parts, find the following
hardware:
"L" shaped Belt Guard Support Bracket
2 Hex Head Screws 5/16-18 × 5/8 in. long
4 Carriage Bolts, 5/16-18 x 3/4 in. long
4 Hex Nuts, 5/16-18
(approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type
(approx. dia. of hole 5/16 in.)
2. Place motor on MOTOR BASE... insert bolts
through holes in base.., then through the motor.
Install Iockwashers, and nuts. Do not tighten.
3. Insert long leg of "L" bracket between motor
base and mounting plate on motor. Do not push
support all the way in. Push in until bracket is
even with motor end hub. This bracket is held in
place as the motor mounting bolts are tightened.
4. Position motor so that edge of MOTOR FOOT
and MOTOR BASE are even ... slide motor all the
way to the RIGHT... tighten the four nuts.
MOTOR MOUNTING
BASE THESE TWO
EDGES EVEN
LOCKWASHER
5/16 IN.
NUT __......_ _ /
5/16-18
CARRIAGE BOLT
5/16-18 X 3/4 IN.
MOTOR BASE
BELT GUARD
SUPPORT
BELT GUARD SUPPORT
INSERTED EVEN WITH
MOTOR END HUB
4. Screw the two 5/16-18 x 5/8 in. motor base
clamp screws part way into tapped holes in
cradle.
5. Lift motor and insert the TWO PINS on motor
base into HOLES in cradle.., push motor in as
far as it will go.
6. Tighten the two motor base clamp screws.
BELT GUARD
SUPPORT
MOTOR BASE
CLAMP SCREWS
5/16-18 X 5/8 IN.
HEX. HD. SCREWS
IO
Loading ...
Loading ...
Loading ...