Loading ...
Loading ...
Loading ...
5. Slide SPREADER ROD into GUARD SUPPORT
until left end of ROD extends approximately 1/4
inch beyond edge of SUPPORT... Snug up Hex
Head Screw in SUPPORT.
6. Attach SPREADERto SPREADER SUPPORTso
that screws are all the way back in the SLOTS of
SUPPORT... tighten screws,
7. Raise ANTIKICKBACK PAWLS (hold in place
with a setscrew wrench. See next illustration).
Align spreader SQUARE to table (be sure insert
is properly adjusted).
!/4-20 HEX \ ! r_ l! _-_
HO.SCREW \ N; '
1/4 IN. LOCKWASHERLT_ I II//_=_
1/4-20 HEX NUT // I _,_"
END OF ROD X\\ \ll_'_-; SCREWS ALL THE
TO \,WAYBACK,NSLOTS
OF EDGE OF (_ ,<_,._ f,_l"_"_l , OF SUPPORT
SUPPORT I! r__,.__ _\ ] '
GUARD SUPPORT
8. Raise Blade Guard . .lift up both
ANTIKICKBACK PAWLS . . insert one of the
SETSCREW WRENCHES in the notches to hold
the pawls out of the way.
9. Lay blade of square or other straightedge
alongside of blade.
10. Loosen Hex Head Screw in GUARD SUPPORT
and move spreader so that it touches blade of
square.., tighten screw.
11. NOTE: The spreader is now square with the
table and approximately in line with the
sawblade. The spreader requires further
adjustment to align it PARALLEL to the blade
and in the MIDDLE of the cut (KERF) made by
the sawblade.
STRAIGHTEDGE
HD.
SCREW
12. IMPORTANT:The SPREADER must always be
PARALLEL to the sawblade in the MIDDLE of
the cut (KERF) made by the sawblade.
NOTE: The spreader isthinner than the width of
the KERF by approximately six thicknesses of !
paper.
SPACE EQUAL TO APPROX.
3THICKNESSES OF PAPER KERF WOOD
BLADE
/
13. Make two folds in a small piece (6 x 6 in.) of
ordinary NEWSPAPER making three
thicknesses.
The folded paper will be used as a "spacing
gauge".
19
Loading ...
Loading ...
Loading ...