Loading ...
Loading ...
Loading ...
Select a piece of smooth straight wood approx.
3/4" thick, at least as long as the rip fence, and at
least 7-1/2" wide (high) to permit clamping of
featherboards,
Attach itto the fence with three Round Head #10
Wood Screws 2 =n.long. To remove the facing,
loosen the screws, slide the facing backward
and pull the screws through the round holes.
WOOD FACING
i
I /
ROUND HEAD
# 10 WOOD SCREWS
If you are making a rip type cut _n material
thinner tl-ran 3/16 in. while the fence is
positioned over the depressed area of table
extension, the facing should be attached to the
fence so that the bottom edge touches the top
surface of the extension. In this case, the facing
must be shorter than the fence. This will prevent
thin material from sliding under the rip fence.
7. MITER GAUGE... head is locked in position
for crosscutting or mitering by tightening the
lock knob. ALWAYS LOCK IT SECURELY
WHEN IN USE.
_HOLD DOWN
LOCK K _ CLAMP
STO 1 \PPIN 45 _ SLOT "_ I J- FAC|NGR\I L_tAUXILIA Y
FOR STOP PIN
There are slots for the stop pin at the 45 degree
right and left positions for conveniently setting
the Miter Gauge to cut miters.
NOTE: The slots for the stop pin and the
graduations are manufactured to very close
tolerances which provide accuracy for average
woodworking. In some cases where extreme
accuracy is required, make a trial cut and then
recheck it.
If necessary, the miter gauge head can then be
swiveled slightly to compensate and then
locked.
Slots are provided in the miter gauge for
attaching AUXILIARY FACING to make it easier
to cut long pieces. Be positive facing does not
interfere with the proper operation of the
sawblade guard.
Select a suitable piece of smooth straight wood.
. . drill two holes through it and attach it with
screws.
NOTE: When bevel crosscutting, attach facing
so that it extends to the right of the miter gauge
and use the miter gauge in the groove to the
right of the blade.
8. BLADEGUARD must always be in place and
working properly for all thru-sawing cuts. That
is, all cuts where the blade cuts completely
through the workpiece.
THUMBSCREW
To remove the guard for special operations,
loosen the thumbscrew and slide the guard off
of the rod. DO NOT DISTURB THE SETTING
OF THE ROD.
When replacing the guard, make sure the PIN in
the rod engages with the NOTCH in the
spreader support. Make sure thumbscrew is
tightened securely.
9. TABLE INSERT is removable for removing or
installing blades or other cutting tools.
SCREW
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE
REMOVING INSERT
A. Use "Shut Down Procedure" Page 30, to
retain calibratiorr.
B. Raise blade guard.
C. Loosen Screw.
D. Lift insert from front end, and pull toward
front of saw.
26
Loading ...
Loading ...
Loading ...