Loading ...
Loading ...
Loading ...
PLOUGHING AND MOLDING
PLOUGHING is grooving with the grain the long
way of the workpiece, using the fence. Use proper
holddowns and feed devices.
MOLDING is shaping the workpiece with the grain
the long way of the workpiece, using the fence. Use
proper holddowns and feed devices.
PLOUGHING
SURFACE MOLDING
RESAWING
RESAWING is known as ripping a piece of wood
through its thickness. Do not attempt to resaw
BOWED or WARPED material. NOTE: To RESAWa
piece of wood wider than 3-3/8 in .... it will be
necessary to remove the blade guard ... and use
the AUXILIARY FENCE/WORK SUPPORT. (See
"Work Helpers").
Clamp it to the table so that the workpiece will
SLIDE EASILY, but not TILT or MOVE SIDEWAYS,
without BINDING between the two fences.
Do not clamp directly to the bottom edge of the table
because the "swivel" of the clamp will not grip
properly. Place a small block of wood between the
bottom edge of the table and the "C" clamp.
WARNING: FOR YOUR OWN SAFETY ...
1. DO NOT "BACK-UP" (REVERSE FEEDING)
WHILE RESAWING BECAUSE THIS COULD
CAUSE A KICKBACK.
2. MAKE FIRST PASS TO A DEPTH SLIGHTLY
LESS THAN ONE-HALF THE WIDTH OF THE
BOARD; KEEP SAME FACE OF BOARD
AGAINST FENCE FOR SECOND PASS AS THE
FIRST PASS,
3. INSTALL BLADE GUARD IMMEDIATELY UPON
COMPLETION OF THE RESAWING
OPERATION.
AUXILIARY FENCE/
WORK SUPPORT
CUTTING PANELS
When cutting panels (whenever fence ispositioned
outside of table surface), ALWAYS use the
AUXILIARY FENCE/WORK SUPPORT.
1. Unlock fence and raise rear end.
2. Position AUXILIARY FENCE/WORK SUPPORT
as shown and attach it with two "(3" clamps,
38
Loading ...
Loading ...
Loading ...