Loading ...
Loading ...
Loading ...
UNPACKING AND CHECKmNG CONTENTS
TOOLS NEEDED
"r
#2 Phillips Type
Pliers _'- Screwdriver
Wrenches
....i./.. ......... ,,...,., ........ I 3/8 in. 7/16 in.
• 1/2 in. 9/16 in.
Combination Square 3/4 in,
COMBINATION SQUARE MUST BE TRUE.
STRAIGHT EDGE OF BOARD
3/4" THICK. THIS EDGE MUST
DRAW LIGHT LINE ON BE PERFECTLY STRAIGHT.
BOARD ALONG THIS EDGE. sT\
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION.
Model 113.226830 Table Saw isshipped complete in
one carton and INCLUDES Motor, Two Table
Extensions, Steel Legs, and Hold Down Clamp.
Separate all parts from packing materials and check
each one with the illustration and the list of Loose
Parts to make certain all items are accounted for
before discarding any packing material.
If any parts are missing, do not attempt to assemble
the table saw, plug in the power cord or turn the
switch on until the missing parts are obtained and
are installed correctly.
Remove the protective oil that isapplied to the table
top and edges of the table. Use any ordinary
household type grease and spot remover.
CAUTION: Never use gasoline, naptha or similar
highly volatile solvents.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth.
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET
UNTIL ALL ASSEMBLY STEPS ARE COMPLETE,
AND YOU READ AND UNDERSTAND THE
SAFETY AND OPERATIONAL INSTRUCTIONS.
HOLDDOWNCLAMP Qty.
A Clamp Assembly ....................... 1
B Wing Screw ............................ 2
C Washer ................................ 2
D Support Rod ........................... 1
A
6
Loading ...
Loading ...
Loading ...