Loading ...
Loading ...
Loading ...
5.Iftoothdoesnottouchthesameamount,.,the
mechanismunderneathmust beadjustedto
makethebladePARALLELto GROOVE,
A.ReartrunnionmustbemovedTOWARDthe
combinationsquareifthereisaspacebetween
markedtoothandendof squareinstep3.
B.ReartrunnionmustbemovedAWAYfromthe
squareif markedtoothpushessquareoutof
positionin thegroove.
FRONT TRUNNION
REAR TRUNNION
NOTE: All six screws can be reached through back
of saw. Use a 9/16-in. wrench. To reach left-hand
front trunnion screws, tilt blade to approximately
25° . After loosening screws reposition blade at 90° .
To make this adjustment:
a. Plug saw into power outlet.
b. Insert yellow key into MASTER switch and
turn on.
c. Press [-_ key.
d. Press and hold _ key to tilt sawblade to
approximately 25° to obtain clearance for
wrench.
e. Turn switch off. Remove yellow key.
f. Loosen all three screws that hold the rear
trunnion and all three screws that hold the
front trunnion.
g. Insert yellow key into MASTER switch and
turn on.
h. Press _ key.
i. Press and hold _ keyto reposition blade
at 90° using a square.
j. Turn switch "OFF", remove yellow key and
unplug saw.
REAR TRUNNION
SCREWS
FT HA
RIGHT "HAND I CENTER
(BEHIND HERE) (BEHIND HERE)
m ",,
FRONT-TRUNNION SCREWS
6. Using a wood block and mallet as shown, move
rear trunnion to right or left as required to realign
the blade. If necessary, shift front trunnion in
similiar manner; but do NOT move front trunnion
unless necessary. Recheck the alignment with
the square.
7. Securely tighten all sixtrunnion screws following
previous steps to tilt blade to obtain clearance for
wrench.
8. Recheck alignment after tightening screws.
Readjust as needed.
EDGE OF TRUNNION
CLAW HAMMER
PLACE BLOCK HERE .............. OR HERE
EDGE OF
REAR OF SAW CRADLE
17
Loading ...
Loading ...
Loading ...