Loading ...
Loading ...
Loading ...
BEVEL CROSSCUTTDNG
BEVEL CROSSCUTTING is the same as
crosscutting except that the wood is cut at an angle
other than 90° with the flat side of the wood.
Adjust the blade to the desired angle.
Set blade elevation to clear top of workpiece by
1/8". Verify this clearance by placing the work next
to the blade.
Use the Miter Gauge in the groove to the RIGHTof
the blade. It cannot be used in the groove to the
LEFT because the blade guard will interfere. Hold
the workpiece with your right hand and the
Iockhandle with your left.
Use the AUXILIARY FENCE/WORK SUPPORT for
additional support of long workpieces.
Lay it across the guide bars to support the
workpiece as near to the end as possible.
Use the Hold-Down Clamp on the miter gauge for
greater accuracy.
In this example a 1" x 6" board will be cut on a 30°
bevel angle.
Have saw calibrated with tip of blade even with table
top. Have guard in place.
STEP" 1- Turn MASTER switch on and press
key. Press number keys [_ _--_
Press _ key. Press _-_ key. Press
numDerkeys, IT] [_ _
[_ (the decimal equivalent of 1-1/4
inches). Press _ key. The blade will
STEP 2-
STEP 3-
automatically raise and tilt to the correct
angle.
Set the miter gauge to the zero position.
Draw a line to the board at thecut-off point
-- long enough for sighting. Use the miter
gauge in the right side groove. Position the
board against the miter gauge face. Align
the cut-off point with the Exact-I-Cut
indicator.
STEP4-
STEP 5-
STEP 6-
STEP 7-
Firmly hold the board in this position. Turn
"ON" the saw motor.
Guide the board through the blade.
Turn the motor "OFF". Wait for the blade
to stop before removing the boards and
returning the miter gauge to the starting
position.
. Press number key _ .
Press
Press _ key. Press I-_ key. Press
number key _ . Press [_ key.The
blade will lower automatically until it is even
with the table and return to 0° bevel.
NOTE: If saw blade is tilted more than 45° from
vertical, the electronic function must be
recalibrated. See page 29.
WORKPIECE
TABLE
COMPOUND MITER CUTTING
COMPOUND MITER CUTTING, is a combination of
miter cutting and bevel crosscutting. The cut is
made at an angle other than 90° to both the edge
and the flat side of the wood.
Adjust the miter gauge and the blade to the desired
angle... Make sure miter gauge is locked.
=14
Loading ...
Loading ...
Loading ...