Loading ...
Loading ...
Loading ...
CAUTION:Beforeturningswitchon,makesurethe
blade guard is correctly installed and operating
properly.
1, MASTER SWITCH:
This is the power on-off switch for the
computer's display and keyboard functions.
(The computer's memory has constant power as
long as saw is plugged into a 120v live power
supply.) Turning this switch off will shut off
power to the saw motor as well as the computer
functions.
\
To turn switch on:
1. Insert yellow key.
\
2. Insert finger under bottom of lever and pull
out.
To turn switch off:
Push lever in.
2. SAW MOTOR SWITCH:
This switch is used to turn the saw motor on and
off.
NOTE: Pushing off either the Saw Motor Switch
or the Master Switch will shut off power to the
saw motor.
NOTE: Only the _-]. and JOG keys will work
when the Saw Motor Switch is "ON". The
elevation only is displayed as long as this switch
is "ON".
Operation of this switch is the same as the
Master Switch except for the yellow key.
WARNING: Do not stand in line with blade when
turning switch on.
Do not cycle motor switch "ON" and "OFF"
rapidly, as this may cause the sawblade to
loosen. In the event this should occur, al!ow the
sawblade to come to a complete stop and
retighten the arbor nut normally, not
excessivel y.
Never leave the saw with power "ON".
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW
TABLE SURFACE. (iF BLADE IS TILTED, RETURN
iT TO VERTICAL (O°) POSITION). ALWAYS LOCK
THE SWITCH "'OFF". WHEN SAW IS NOT IN USE..
• REMOVE KEY AND KEEP IT IN A SAFE PLACE...
ALSO... IN THE EVENT OF A POWER FAILURE
(ALL OF YOUR LIGHTS GO OUT) TURN SWITCH
OFF ... LOCK IT AND REMOVE THE KEY. THiS
WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON.
3. DISPLAY:
NOTE: Readout on display is in decimals. There is a
conversion chart for converting fractions to
decimals on page 55 of this manual.
MINUS
INDICATOR NUMBERS
R
II TO LOCK I_
DECIMAL POINTS
The display gives the user four pieces of
information.
1. The decimal point shows what function,
either ELEV OR BEVEL is being displayed.
2. The numbers show either the present
position of the blade or the entered
destination for programmed operation.
3.The minus indicator in the upper left hand
corner lights when the displayed number is
negative (less than the "zero" position) or
key is pressed after a
To lock switch: 4. The flashing !_"indicates that the saw needs
Hold lever in with one hand while remowng calibrating. The flashing'E will only be
yellow key with the other hand. displayed when the saw requires calibrating
24
Loading ...
Loading ...
Loading ...