Loading ...
Loading ...
Loading ...
City Series CC40E-11 | 25
requirements
installer's information
Locating Your Gas Fireplace
1. When selecting a location for your fireplace,
ensure that the clearances are met.
2. The appliance must be installed on a flat, solid,
continuous surface For example a wood, metal
or concrete floor or in a raised (on the wall) ap-
plication. The appliance must be installed on
a metal or wood panel extending the full width
and depth of the appliance.
3. The CC40LE/CC40RE Direct Vent Gas Fire-
place can be installed in a recessed position
or framed out into the room as in A and B. See
Diagram 1.
A) Corner Left
A
B
Diagram 1
CC40LE/CC40RE
CC40LE/CC40RE
B) Corner Right
4. For bedroom installations, check with local
codes before installation. This appliance is
offered with a remote control.
5. The CC40LE/CC40RE Direct Vent Gas Fire-
place is approved for alcove installations, see
"Clearances" section for details.
6. We recommend that you plan your installa-
tion on paper using exact measurements for
clearances and floor protection before actually
installing this appliance. Have an authorized
inspector, dealer, or installer review your plans
before installation.
Note: For vent terminations refer to "Exterior
Vent Termination Locations" section.
Unit Assembly Prior to Installation
Before you start
The CC40LE/CC40RE has 4 standoffs, 2 on one side and 2 at the back that need assembly before
installation.
tooltip
Side and Back Standoff Assembly CC40LE/CC40RE
The standoffs are shipped in a flat position and must be folded into shape and attached.
Take each standoff off the unit by removing one screw and bend into the correct shape. Slot the 2 tabs
of the stand off into the slots in the unit and attach the other end with one screw.
Standoff
locations
Back Standoff Assembly CC40LE/
CC40RE
Take each standoff off the unit by removing one
screw. Bend into the correct shape (see above). Slot
the 2 tabs of the stand off into the slots in the unit
and attach the other end with one screw.
Loading ...
Loading ...
Loading ...