Loading ...
Loading ...
Loading ...
APPENDIX ➤ When surround effect is not enough En 101
2
Use advanced setup (p. 86) to configure the sound reflection board.
Set “YRB FL” (FL), “YRB FR” (FR), “YRB SL” (SL), and “YRB SR” (SR) to
“YES” depending upon the position of the sound reflection board to be
installed.
Color bars are displayed across the entire TV screen. This makes it easier to
recognize whether the TV screen is reflected in the panel when determining
the proper angle of the panel in step 4, to the left or right.
3
Adjust the height.
Adjust the height of the sound reflection board panel based on the position of
the unit and the sound reflection board, as well as the listening position.
See the YRB-100 Owner’s Manual for more information.
4
Adjust the angle of the panel left or right.
Adjust the angle of the panel so that sound beams are reflected toward the
listening position.
Turn on the TV and dim the lights in the room. If you see the TV screen (color
bar display) reflected in the panel from your listening position, the angle of the
panel is properly adjusted.
See the YRB-100 Owner’s Manual for more information.
5
Press the z key to turn this unit off. Press it a second time to turn
this unit on again.
6
Plug the IntelliBeam microphone into this unit and then perform
“AUTO SETUP” (Beam+Sound optimize) from the “IntelliBeam”
menu (p. 31).
Be sure that the channels (FL, FR, SL, and SR) configured for the sound
reflection board are displayed for “YRB” on the SHOW RESULT screen.
An asterisk (*) is displayed with a channel exhibiting poor sound beam
reflection.
Should this occur, follow the instructions below to re-adjust the panel.
a Adjust the height and angle of the sound reflection board panel in accordance with
installation conditions.
b Use “Channel Level” in the setup menu (p. 75) to confirm that the test sound is
successfully reflected.
For greater precision, perform “AUTO SETUP” in the “IntelliBeam” menu, and then
confirm that the asterisk (*) is no longer displayed with the channel.
If the asterisk (*) continues to be displayed, or if there is still no test sound
reflected from the direction of the sound reflection board, follow directions in
the YRB-100 Owner’s Manual to adjust sound beams manually.
SHOW RESULT
MEASUREMENT COMPLETE.
ENVIRONMENT CHECK:Success
FRONT :Stereo
SURROUND :Beam
SUBWOOFER:Wired
YRB:FL SL*
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
Indicates poor reflection
Loading ...
Loading ...
Loading ...