Loading ...
Loading ...
Loading ...
WARNING: Avoid electric shock, tf the outlet
you are planning to use for this saw is of the
two prong type, DO NOT REMOVE OR ALTER
THE GROUNDING PRONG iN ANY MANNER.
Use an adapter, as shown, and always connect
the grounding lug to a known ground, such as
to a properly grounded outlet box. Not all out-
let boxes are properly grounded, if you are not
sure the outlet box is properly grounded, have
it checked by a qualified electrician.
CHANGING MOTOR VOLTAGE
WARNING: Electric shock can kill. To avoid
shock, never connect plug to power source
outlet until all assembly steps are completed.
Unplug saw before making or changing any
connections.
1. Connections for 120V AC Operation
a. For operation on 120 volts, the black power lead
is connected to spade terminal beside copper
post. The white power lead is connected to spade
terminal beside silver post. The two movable links
must be in position shown in Figure 1. The red
motor lead is connected to terminal "B".
b. The movable links pivot on the center most
screws, After links have been correctly posi-
tioned, be sure to tighten these screws to insure a
good electrical connection,
120 VOLT CONNECTION
b. The movable links pivot on the center most
screws. After links have been correctly posi-
tioned, be sure to tighten these screws to insure a
good electrical connectior_.
240 VOLT CONNECTION
Copper Post
A
Black Power Ground Screw
Spade Terminals Links in This
Position
White Power Lead
Silver Post
Red
B
Figure 2
c. Replace the 120v power cord plug with a (3
blade) 240v 15 Amp U.L. listed plug (see illustra-
tion below). Connect the power cord white and
black leads, respectively, to the two "hot" plug
blades and connect the power cord grounding
wire to the plug ground prong.
240V PLUG & RECEPTACLE
Grounding Blade Is
Longest Of 3 Blades
Copper Post A
Green _-
Black Power Lead Ground Screw
Spade Terminals Links In This
Position
White Power Lead
Red
B
Silver Post
Figure I
2. Connection for 24.0V AC Operation
a. For operation on 240 volts, the black power lead
is connected to spade terminal beside copper
post. The white power lead is connected to spade
terminal beside silver post. The two movable links
must be in position shown in Figure 2. The red
motor lead is connected to terminal "B".
Grounded Outlet Box
No Adapter Is
Available For
This Type Plug
d. Plug your saw into a 240v, 15-Amp, 3-blade
receptacle.
e. Make certain the receptacle is connected to a
240v AC power supply through a 240v branch cir-
cuit having at least a 15-amp capacity and pro-
tected by a 15-amp, time-delay fuse or circuit
breaker.
Loading ...
Loading ...
Loading ...