Loading ...
Loading ...
Loading ...
10.Makesurebladeis90°totable.,.raise it all the way
up.
11. Lift motor until edge of washer (see illustration) is
even with _nd of slot. in this position, pull motor
toward you(pins will slide in the cradle) until belt is
TIGHT...make sure washer is still even with end of
slot...tighten the two MOTOR BASE CLAMPS
SCREWS.
I2. Put your hand around the belt half way between
the two 0ulteys and squeeze belt until two sides of
belt touch, The motor should move freely as you
squeeze the belt. If motor does not move freely,
belt tension must be readjusted.
INSTALUNG BELT GUARD
1. From among the loose parts find the following hard-
ware:
1 Belt Guard Support Bracket
1 Belt Guard Support
1 Belt Guard
2 Self Threading Screws, 10.32 x 1/2 in. tong
2. Remove the belt and motor pulley.
3. Screws furnished with guard are "self threading".,.
screw them into holes in BELT GUARD SUPPORT
BRACKET. then remove them.
4. Position BELT GUARD SUPPORT BRACKET and
BELT GUARD SUPPORT as shown and install the
screws...make sure motor shaft is in CENTER of
hole in SUPPORT
BELT GUARD
SUPPORT BRACKET
TWO HOLES
CLOSEST
TOGETHER
10-32 X 1/2"
SELF-THREADING
SCREW
/
BELT GUARD SUPPORT
5. Install three CLIPS (furnished with guard) 90
degrees apart starting with one clip at the end of the
guard as shown...LONG END of clip must be on
outside of guard pointing away from opening n
guard.
BELT GUARD
OPENING
J CLIPS
\
LONG END
36
Loading ...
Loading ...
Loading ...