Loading ...
Loading ...
Loading ...
RNSTALLUNG FRONT RIP FENCE GUIDE
BAR
1. From among the loose parts find the following hard-
ware:
,
,
4 Sq. Head Screws, 5/16-18 x 1" long
2 Sq. Head Screws, 5/16-18 x 3/4" long
6 External Lockwashers, 5/16" inside diam.
6 Flat Washers, 21/64" inside diam.
6 Hex Nuts, 5/16-18
1 Front Guide Bar 70" long
Slide the heads of four 5/16" x 1" SQ. head screws
into the top slot of the guide bar until they are in the
central area. Then slide one 5/16" x 3/4" SQ, head
screw into the left and right ends of the top slot of the
guide bar,
Place guide bar on table top withtop down and bolts
facing toward you. Position guide bar so that right
end, when facing saw, is 15" past end of right exten-
sion. This should leave 11" extending past left exten-
sion.
4.
Slide the 1" screws in slot until they line up with the
four holes in the saw table. Slide the 3/4" screws
until they line up with the holes in the brackets
attached to the extensions,
.
Carefully lift and roll the front guide bar until screws
face holes in saw table and brackets. When all six
holes are in line, push front guide bar against saw
tables and extensions.
1 " SQ, HD. SCREW
5/16" EXTERNAL
LOCKWASHER
21164" WASHER
SQ. HEADSCREW
3/4" SO, HD. SCREW 1" SQ, HD. SCREW
WARNING: Tighten bolts in the proper order.
improper tightening sequence can twist the fence
rail Twisted rail can misalign fence, A misaligned
fence can cause binding or kickback. You could
be hit or cut.
SAW TABLE
EXTENSION
8RACKET
SO. HEAD SCREW
FRONT
GUIDE BAR
FLAT WASHER
511_1B
HEX NUT
LOCKWASHER
2!
Loading ...
Loading ...
Loading ...