Loading ...
Loading ...
Loading ...
CHECKgNG BLADE SQUARENESS TO
TABLE
IMPORTANT; BLADE must be SQUARE (90
degrees) to TABLE, in order to proceed with
assemblly.
1. Make sure saw is off and unplugged,
2. Turn ELEVATION handwheel clockwise until blade is
up as high as it will go,
3, Check for BLADE SQUARENESS..,if blade is not
square to table, adjust it at this time,
NOTE: The combination square must be "true" - see
start of "Unpacking and Checking Contents" section for
checking method used to check square.
Refer to "BLADE TILT, OR SQUARENESS OF BLADE
TO TABLE" in the "ADJUSTMENT" section of this man-
ual for instructions on how to square blade to table.
MAKE SURE SQUARE
IS NOT TOUCHING
TIP OF TOOTH
ASSEMBLING STEEL LEGS
From among the loose parts, find the following
Hardware:
40 Truss Head Screws, 1/4-20 x !/2 in. long Itop of
screw is rounded)
40 Lockwashers, 1/4 in. External Type (approx. diG, of
hole 1/4 in.)
40 He× Nuts, 1/4-20 (approx. diG. of hole 1/4 in.)
8 Hex Nuts, 3/8-16 (approx. diG. of hole 3/8 in.)
4 Leveling Feet
....... i== I,i .
Assemble the legs as shown:
1. Insert the Truss Head Screws through the holes in
the legs, then through the holes in the upper stiffen-
ers. MAKE SURE THE SCREWS GO THROUGH
THE HOLES IN THE UPPER SIDE STIFFENERS
MARKED "X".
2. Install the Iockwashers. Screw on the nuts hand
tight.
3. Insert the Truss Head Screws through the holes in
the Legs, then through the holes in the lower stiffen-
ers.
MAKE SURE THE SCREWS GO THROUGH THE
HOLES IN THE LOWER STIFFENERS MARKED
4. Install the Iockwashers, Screw on the nuts but do not
tighten until completely assembled,
5. After completing the leg assembly as shown, tighten
all the nuts.
6. install leveling feet.
7. Adjust leveling feet as follows:
a. Move saw to desired location.
b. With 9/! 6 inch wrench loosen bottom nut,
c. Back offtop nut byhand.
d, Raise or lower foot by adjusting bottom nut using
9/16 inch wrench.
e. Snug top nut against ins;de of leg by hand.
f. Tighten all four bottom nuts using 9/16 inch
wrench,
1/4-20 X 1/2 IN.
TRUSS HEAD SCREW
©
1/4-20
HEX NUT
1/4 IN. LOCKWASHER
___
HEX NUT
15
Loading ...
Loading ...
Loading ...