Loading ...
Loading ...
Loading ...
8. Find the "0" inch mark on the end of the 30" long
right measuring tape. Slide this end of the measuring
tape under the right side of the indicator and push
tape along top surface of rip fence guide bar.
9. Move measuring tape under plastic indicator until
two inch mark on measuring tape is straight under
red line on center of indicator.
10. Hold measuring tape in this position and draw a
pencii mark across rip fence guide bar at left end of
measuring tape,
11, Remove rip fence from saw,
12, Install right front measunng tape as follows:
A. Place measuring tape with "0" inch mark on pen-
cil mark you drew across left end of guide bar,
B. While holding measuring tape in position lift left
end and peel back about six inches of protective
coating to expose adhesive on underside of
measunng tape, Very carefully lower left end of
measuring tape back down on rip fence guide
bar making sure the measuring tape is lined up
properly with the pencil mark. Press left end of
measuring tape down against guide bar so
adhesive will hold measuring tape in place.
C, Raise measuring tape and peel back another st×
inch section of protective covering. Now carefully
lower measuring tape agmnst guide bar so it
remains lined up and then cress down so adhe-
sive will hold it in place,
D. Continue this procedure until the full length of
the measuring tape is in place on the guide bar.
13, Place rip fence on left side of blade.
O" MARK 2" MARK RED LINE
i ON INDICATOR
l_i J I -
DRaW/PENCIL P FENCE HEAD !
MARK HERE
PENCIL MARK
FRONT
RiP FENCE
--- TAP SURtNG GUIDE BAR
! 4. Usinga tape rule measure two inches out from the
left side of the blade. Position rip fence so right side
of fence is at this two inch mark.
15. Lock np fence in this position
16. Followthe same procedure used to install the right
measuring tape except:
A, The left measuring tape is 24" long.
B, The pencil mark you make across the guide bar
should be at the right end of the tape.
C. The end of the measuring tape with "0" inch
mark must be pushed under the left side of the
rio fence and the left side of the indicator.
D.When peeling back protective coating to expose
adhesive work from the right end of the measur-
ing tape.
17, The measuring tapes can now be used together
with the rip scale indicator to provide a quick
method for positioning the rip fence to produce
boards of the width you desire, If you want to rip a
board 4 inches wide, simply slide the rip fence
along the front guide bar until the ,ed line in the
center of the plastic indicator is positioned directly
above the four inch line on the measuring tape.
Lock the fence in this position and rip the board.
NOTE: If extreme accuracy is required when ripping,
you should not use this method to position the fence
Instead. use a prec=sion measunng instrument to set
the rip fence the exact distance away from the blade.
28
Loading ...
Loading ...
Loading ...