Loading ...
Loading ...
Loading ...
BLADE T_LT, OR SQUARENESS OF BLADE
TO TABLE
WT,:>t _Te bevel ponte is !,oi _t n9 directly to the '0'
rra:k (_ _e, ,_,_,,, scae. the sawMade st ou_d make a
• _ ,,0 t _,, e_., to the taHe
90' POSiTiON
;% c qec <for SQUARENESS:
[-6_G7 For your own safety, turn switch ]
i "OFF' a_d remove p_ug from power source out-
]
I leL
I Raise b_ade a_tthe way UP..:raise blade guard.
2 Operate the tiltqock handie (COUNTERCLOCK
WISE) to {oosen the tiit c_amp screw.
O
NOTE: Handle is spring loaded for engagement with
screw head - must be pushed irward for disengage
ment whenever necessary to obtain a few grip on
screw head.
3. TILT' blade a few degrees to the LEFT: .qow tiit b!ade
back to the R_GHT as far as it wifl go.
4 P_aoe the square against blade. Make sure sqdare s
not touchiT_g the TIP of one of the saw TEETH.
[i..............................................J
5. Blade sbod_d be square with table and pointer
sho@d ' '
po,r,t _.,_'0'
i n l u
If biade is SQUARE to table:
A. Check Pointer
IF POINTER DOES NOT point to the "0" mark on the
bevel scale;
A. Remove Elevation HandWneet.
B. Loosen screw and adjust pointer to "0' mark
using medium screwdriver.
C, Install Elevation Hand_,_eeL
r , i •
59
Loading ...
Loading ...
Loading ...