Loading ...
Loading ...
Loading ...
44 GETTING TO KNOW YOUR VEHICLE
3. Place the base of the exterior mirror into the
hole on the door, and support it while
attaching the three mirror bolts through the
inside of the door using a #T40 Torx head
driver.
Attach Exterior Mirror
NOTE:
Recommended torque for the mirror bolts
is 5.9 ft· lb / 8.0 N·m.
4. Repeat steps 1-3 on the opposite side front
door.
Half-Door Removal
To remove the half-doors, repeat the installation
steps in reverse order.
NOTE:
When removing the upper half-doors, push upward
firmly on the middle of the upper half-door until the
posts detach from the lower half.
Push Upward To Remove Upper Half-Door
STEERING WHEEL
TILT/TELESCOPING STEERING COLUMN
This feature allows you to tilt the steering column
upward or downward. It also allows you to lengthen
or shorten the steering column. The tilt/
telescoping control is located below the steering
wheel at the end of the steering column.
Tilt/Telescoping Steering Column Control
To unlock the steering column, push the control
downward (toward the floor). To tilt the steering
column, move the steering wheel upward or
downward as desired. To lengthen or shorten the
steering column, pull the steering wheel outward
or push it inward as desired. To lock the steering
column in position, push the control upward until
fully engaged.
1 — Support Mirror From Outside
2 — Attach Three Mirror Bolts From Inside
1 — Fully Seated Upper Half-Door
2 — Push Upward On Middle Of Upper Half-Door
WARNING!
Do not adjust the steering column while driving.
Adjusting the steering column while driving or
driving with the steering column unlocked, could
cause the driver to lose control of the vehicle.
Failure to follow this warning may result in
serious injury or death.
22_JT_OM_EN_USC_t.book Page 44
Loading ...
Loading ...
Loading ...