Loading ...
Loading ...
Loading ...
426 SERVICING AND MAINTENANCE
FRONT FOG LAMP
NOTE:
We advise seeing an authorized dealer for service
on LED and Halogen front fog lamps.
See below steps to replace:
1. Reach under the vehicle to access the back of
the front fog lamp.
2. Disconnect the wire harness connector from
the front fog lamp connector receptacle.
3. Firmly grab the bulb by the two latch features
and squeeze them together to unlock the bulb
from the back of the front fog lamp housing.
4. Pull the bulb straight out from the keyed
opening in the housing and then connect the
replacement bulb.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they
are replaced as an assembly.
REAR TAIL, STOP, TURN SIGNAL, AND BACKUP
LAMP
See below steps to replace:
1. Remove the two screws that pass through the
bed sheet metal.
Tail Lamp Screws
2. Pull the outboard side of the lamp rearward,
far enough to unsnap the two receptacles on
the outboard side of the lamp housing, from
the two plastic snap post retainers in the outer
box side panel.
3. Remove the screws from assembly bracket to
access the three bulb sockets.
Assembly Bracket
4. Rotate the appropriate socket a quarter turn
counterclockwise, then remove it from the
housing.
5. Pull the bulb straight from the socket to
replace.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
The stop lamp is mounted on the tailgate. If service
is needed, obtain the LED assembly from an
authorized dealer.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
22_JT_OM_EN_USC_t.book Page 426
Loading ...
Loading ...
Loading ...