Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 99
2. Install the door frames. Start with both front
doors, followed by both rear doors. Apply the
appropriate torque specifications for the door
frame Torx head fasteners Ú page 108.
3. Unsnap and remove the storage bag. This bag
should be discarded. It was intended as a
protective cover for shipping only.
4. Ensure the top is secured with the provided
hook-and-loop fasteners, then lift the soft top
onto the rear of the cab. Line up the locater
pins (one on each side of the soft top) with the
rear door frames.
Step Four
5. Using the provided #T50 Torx head driver and
ratchet, install and tighten the Torx fasteners
by turning them clockwise. Secure them until
they are snug, being careful not to
cross-thread the fasteners or overtighten.
Refer to the following table for recommended
torque specifications. Repeat on the opposite
side.
Step Five
Step Five
CAUTION!
Failure to follow the next steps could result in
damage to the soft top or vehicle.
Torque
Specification
For Torx
Fasteners
Maximum Minimum
119.5 in-lb
(13.5 N·m)
150.5 in-lb
(17.0 N·m)
106.2 in-lb
(12.0 N·m)
CAUTION!
Do not overtighten Torx fasteners. You can strip
the fasteners if they are overtightened.
2
22_JT_OM_EN_USC_t.book Page 99
Loading ...
Loading ...
Loading ...