Loading ...
Loading ...
Loading ...
#
To remove: using a suit able object, turn two
mounts 1 of cover 2 in an counter-clock‐
wise direction as far as they will go.
#
Remove the unlocked cover 2 from the
wheel arch liner by pulling it upwards.
#
To install: insert cover2 at bottom of the
wheel arch liner.
#
Using a suitable object, tur n the two mounts
1 of the cover 2 in clockwise direction as
far as they will go.
Replacing bulbs in the halogen headlamp
Requirements
The lighting system is switched off.
Low beam/high beam:
R
A H7 55 W light bulb is available.
R
The hood is open.
Turn signal lights:
R
A PWY 24 W light bulb is available.
R
The cover in the front wheel arch has been
removed.
1
Low-beam headlamps
2
High beam
3
Turn signals
#
Turn the relevant housing cover 1–3 coun‐
ter-clockwise and remove it.
#
Low beam / high beam: turn the socket
counter-clockwise and remove it.
#
Indicator: turn the socket counter-clockwise,
release it and remove it.
#
Pull the bulb out of the socket.
#
Insert the new bulb into the socket such that
the entire base of the bulb is resting on the
bottom of the socket.
#
Insert the socket and turn it clockwise.
#
Press on the housing cover and turn it clock‐
wise.
#
Turn signal lights: install the cover in the
front wheel arch.
Changing the rear bulbs (vehicles with halo‐
gen headlamps)
Opening and closing the side trim panels in
the trunk
#
To open: release right-hand or left-hand side
trim panels 1 at the top and remove.
#
To close: re-insert side trim panel 1.
130
Light and visibility
Loading ...
Loading ...
Loading ...