Loading ...
Loading ...
Loading ...
En
35
Changing the settings
Switching the backspin length
It is possible to make the unit perform back spin longer than the actual
jog wheel rotation amount when back spin operation of jog wheel is
performed.
The length of back spin operation can be selected from one of three
types: short, normal, and long.
! By default, back spin length normal is set.
Press any of performance pads 6 to 8 on the right
deck.
Pad 6 lit: Back spin length normal
Pad 7 lit: Back spin length short
Pad 8 lit: Back spin length long
Disabling optimization of crossfader
MIDI messages
When the [CROSS FADER CURVE] switch on the front panel is set to ,
the crossfader MIDI messages output method is optimized to improve
crossfader response during scratching.
With this setting, optimization of crossfader MIDI messages is disabled.
! By default, optimization of crossfader MIDI messages is enabled.
! Optimization of crossfader MIDI messages is performed only when
the [CROSS FADER CURVE] switch is set to .
Press the [KEY LOCK] button on the left deck.
! [KEY LOCK] button lit: Optimization of crossfader MIDI messages is
enabled.
! [KEY LOCK] button off: Optimization of crossfader MIDI messages is
disabled.
Launching the setting utility software
automatically
When connecting the USB cable to PC/Mac, the setting utility software
on the PC/Mac can be launched automatically.
By default, the setting utility software is not launched automatically.
Press the [KEY LOCK] button on the right deck.
! [KEY LOCK] button lit: the setting utility software is launched
automatically.
! [KEY LOCK] button off: the setting utility software is not launched
automatically.
Adjusting the sensitivity of the jog
wheel touch sensor
This unit is equipped with a mode for adjusting the sensitivity of the jog
wheel touch sensor.
! The value set in the jog wheel sensitivity adjustment mode is retained
even when this unit is turned off.
! The sensitivity of the left and right jog wheel can be adjusted
separately.
The following example describes the procedure for adjusting the
sensitivity of the jog wheel on the left deck.
1 Connect this unit to the PC/Mac via an included
USB cable.
2 Press the [DECK1] or [DECK3] button while
pressing the [SHIFT] button.
The sensitivity adjustment mode is set, and the current sensitivity is
displayed on the indicator in the center area of the jog wheel.
! During the sensitivity adjustment mode, perform the next
operation within 3 seconds. (If more than 3 seconds pass after
a button was pressed, the set value is stored and the indicator
returns to the normal display.)
3 Press the [DECK1] or [DECK3] button while
pressing the [SHIFT] button.
The sensitivity increases each time the [DECK1] button is pressed and
decreases each time the [DECK3] button is pressed.
When the jog wheel sensitivity is adjusted, the set sensitivity is displayed
on the indicator in the center area of the jog wheel.
Low sensitivity (–10) No adjustment (±0) High sensitivity (+10)
The jog wheel sensitivity can be adjusted in 37 steps.
! By default, “No adjustment (±0)” is set.
! To adjust the sensitivity of the jog wheel on the right side, press
the [DECK2] or [DECK4] button while pressing the [SHIFT]
button.
4 After setting is completed, wait for 3 seconds.
When 3 seconds have passed after pressing the button, the set value is
stored and the indicator returns to the normal display.
Loading ...
Loading ...
Loading ...