Loading ...
Loading ...
Loading ...
En
11
Part names and functions
Rear panel
1 MASTER OUT 1 terminals
Connect powered speakers, etc., here.
! Compatible with XLR connector type balanced outputs.
Do not connect any terminal which provides phantom power to
these terminals or a power cord of another product.
2 MASTER OUT 2 terminals
Connect to a power amplifier, etc.
! Compatible with RCA pin-jack type unbalanced outputs.
3 BOOTH OUT terminals
Output terminals for a booth monitor, compatible with balanced or
unbalanced output for a TRS connector.
The master channel sound can be output from the [BOOTH OUT]
terminals regardless of the audio level set for the master channel.
! The sound will be distorted if the level is raised too high when
using unbalanced outputs.
! The default setting of booth monitor output has been set to
output the microphone sound. In the utilities mode, it is possible
to set not to output the microphone sound.
= “About the setting utility” (p.31)
4 MIC2 terminal
Connects a microphone here.
! The input select switch on the mixer section must be set to
[MIC2].
5 LINE terminals
Connect to a DJ player or other line level device.
! The input select switch on the mixer section must be set to
[LINE].
6 LINE/PHONO input terminals
Connect to a phono level (for MM cartridge) output device such as
an analog turntable or line level output device such as a DJ player.
Depending on the device connected, the terminal function can be
switched using the [LINE/PHONO] switch at next to the terminal.
7 SIGNAL GND terminal
Connect an analog turntable ground wire here. This helps reduce
noise when the analog turntable is connected.
8 LINE/PHONO switches
9 MIC1 terminal
Connects a microphone here.
! The input select switch on the mixer section must be set to
[MIC1].
! Either an XLR connector or a phones plug (Ø 6.3 mm) can be
used.
a Kensington security slot
Connects a wired lock for theft prevention.
b USB terminals
Connects to a PC/Mac.
! Connect this unit and the PC/Mac directly using the included
USB cable.
! A USB hub cannot be used.
c STANDBY/ON switch
This switches this unit’s power between on and standby.
d DC IN terminal
Connect to a power outlet using the included AC adapter (with the
power plug mounted).
! Connect the AC adapter after all the connections between
devices have been completed.
! Only use the included AC adapter.
e Cord hook
Catch the AC adapter’s power cord on this hook when using this
unit.
! The sound will be interrupted if the AC adapter is disconnected
during playback.
Loading ...
Loading ...
Loading ...