Loading ...
Loading ...
Loading ...
Common Settings
54 CP1 Owner’s Manual
Reference
Fourth page: Controller settings
Editing Sequence: Press the [COMMON] button Navigate to the fourth page using the [PAGE R] button Turn Knobs 1 to 4
Source This parameter is used to select the controller to be edited.
Setting values: PtchBend (Pitch Bend wheel), FC1 (Foot Controller 1), FC2 (Foot Controller 2), FSAssign
(assignable foot switch), Soft (Soft pedal), or Sostnuto (Sostenuto pedal)
FC1/FC2 .......Foot controllers connected to the [1] and [2] foot-controller jacks.
FSAssign ......Foot switch connected to the [ASSIGNABLE] foot-switch jack
Soft ...............Pedal connected to the [SOFT] foot-switch jack
Sostnuto .......Pedal connected to the [SOSTENUTO] foot-switch jack
1Dest (Destination 1)
2Dest (Destination 2)
These parameters are used to assign the controller selected using Source with a function for Part 1 and Part
2, respectively.
Setting values: See the following table.
Source Destination
PtchBend (Pitch Bend) off or MdEffect (Modulation Effect)
FC1 or FC2
(Foot Controller 1 or Foot Controller 2)
off, Volume, or MdEffect
FSAssign (assignable foot switch) off, Vibrato, MdEffect, or PowerAmp (Power Amplifier)
Soft (Soft pedal) off, Soft, Vibrato, MdEffect, or PowerAmp
Sostnuto (Sostenuto pedal) off, Sostnuto, Vibrato, MdEffect, PowerAmp
NOTE If “MdEffect” is selected as a destination with Source set to “PtchBend”, “FC1”, or “FC2”, one of the
parameters from the Modulation Effect block will be assigned to the corresponding controller, depending
on the type of effect selected. For details on the actual parameter that will be assigned, see the Modulation
Effect block’s parameter list in the Data List booklet. Specifically, the parameter marked in the Control
field will be assigned to the controller.
NOTE When Source is set to “FSAssign”, “Soft”, or “Sostnuto”, the function assigned as the destination can be
turned on and off by pressing the corresponding controller. If “Vibrato”, “MdEffect”, or “PowerAmp” is
selected as the destination, pressing the controller will have the same effect as pressing the
corresponding [PRE-AMPLIFIER], [MODULATION EFFECT], or [POWER-AMPLIFIER/COMPRESSOR]
button. For more details, see Turning Performance Blocks On & Off from the Basic CP1 Operations section
(page 31)
Mode (Switch Mode) This parameter is displayed only when Source has been set to “FSAssign”, “Soft”, or “Sostnuto”. It is used to
specify whether the controller in question will operate as a latch-type or momentary-type controller. Latch-
type switches remain on or off after being operated, while momentary-type switches remain on only while
the switch is being operated.
Setting values: momentary or latch
NOTE When “Soft” or “Sostnuto” is selected as a destination, the controller will perform momentary-type
operation, regardless of the Mode setting.
Loading ...
Loading ...
Loading ...