Loading ...
Loading ...
Loading ...
Reverb
50 CP1 Owner’s Manual
Reference
Reverb
The Reverb block can be used to apply a reverberation type effect to both Part 1 and Part 2.
Editing Sequence: Press and hold the [REVERB] button (for at least one second) Turn Knobs 1 to 5
RevType
(Reverb Type)
This parameter is used to select the type of reverb to be applied.
Setting values: RichHall, RichPlt, RichRoom, WoodRoom, Room1, Room2, Stage1, or Stage2
RichHall (Rich Hall) Emulation of hall acoustics with a rich, deep reverb sound.
RichPlt (Rich Plate) Emulation of a rich, sustained plate sound.
RichRoom (Rich Room) Emulation of room acoustics with a gentle reverb sound.
WoodRoom (Woody Room) Emulation of room acoustics with a warm reverb sound.
Room1 Emulation of room acoustics with a crisp reverb sound.
Room2 Emulation of room acoustics with a deeper reverb sound.
Stage1 Emulation of stage acoustics with wide, sustained reverb sound.
Stage2 Emulation of the reverb typical of a smaller stage.
RevTime
(Reverb Time)
This parameter is used to set how long it takes for the reverb sound to fade to silence.
Setting values: WoodRoom: 0.3 to 10.0 (seconds), Other reverb types: 0.3 to 30.0 (seconds)
1RevSend
(Reverb Send 1)
These parameters are used to set how much of the output signal from Part 1 and Part 2, respectively, is sent
to the reverb effect. Higher values produce a more pronounced reverb sound.
Setting values: 0 to 127
2RevSend
(Reverb Send 2)
FBHiDamp
(Feedback High Damping)
This parameter is used to adjust the brightness of the reverb sound. At higher settings, it takes longer for the
high-frequency component to decay, producing a brighter overall reverb sound. This parameter is not
displayed on-screen when RevType has been set to “WoodRoom”.
Setting values: 0.1 to 1.0
HPF
(High-pass Filter Cutoff)
This parameter is used to set the cutoff frequency for the Reverb block’s high-pass filter.
Setting values: 20Hz to 8.0kHz
Loading ...
Loading ...
Loading ...