Loading ...
Loading ...
Loading ...
171
3 Setting Noise ReductionN
Noise reduction is possible with images exposed for 1 sec. or longer.
1
Select [Long exp. noise
reduction].
Under the [z4] tab, select [Long
exp. noise reduction], then press
<0>.
Long Exposure Noise Reduction
When [Multi Shot Noise Reduction] is Set
If there is significant misalignment in the image due to camera shake, the
noise reduction effect may become smaller.
If you are handholding the camera, keep it steady to prevent camera
shake. Using a tripod is recommended.
If you shoot a moving subject, the moving subject may leave
afterimages.
The image alignment may not function properly with repetitive patterns
(lattice, stripes, etc.) or flat, single-tone images.
If the subject’s brightness changes as the four consecutive shots are
taken, irregular exposure in the image may result.
After shooting, it may take some time to record an image to the card after
performing noise reduction and merging the images. During the
processing of the images, “buSY” will be displayed in the viewfinder, and
you cannot take another picture until the processing is complete.
You cannot use AEB and white balance bracketing.
If [z4: Long exp. noise reduction], AEB, or white balance bracketing
is set, [Multi Shot Noise Reduction] cannot be set.
The [Distortion] setting will be set automatically to [Disable].
Flash photography is not possible. However, the AF-assist beam will be
emitted according to the setting of [5: AF-assist beam firing] under
[54: Custom Functions(C.Fn)].
You cannot set [Multi Shot Noise Reduction] for bulb exposures.
If you turn off the power, change the shooting mode to a Basic Zone
mode, shoot a bulb exposure, or shoot a movie, the setting will
automatically be changed to [Standard].
[z4: Dust Delete Data] cannot be set.
Loading ...
Loading ...
Loading ...