PSR-A3000 User Manual

Loading ...

PSR-A3000 Owner’s Manual 159

Songs

6 Press the [I] (SAVE) button to carry out the Save operation.

For details, refer to page 28.

NOTICE

The edited Song data will be lost if you select another Song or turn off the power to the instrument without carrying out the Save operation.

Re-recording a Specific Section—Punch In/Out

When re-recording a specific section of an already-recorded Song, use the Punch IN/OUT function. In this method,

only the data between the Punch In point and the Punch Out point is overwritten with the newly recorded data. Keep

in mind that the notes before and after the Punch In/Out points are not recorded over, although you will hear them

play back normally to guide you in the Punch In/Out timing.

NOTE The Style Retrigger function (page 112) cannot be used when recording over existing data (overdubbing).

1 Select the desired Song for re-recording.

2 Call up the operation display.

[FUNCTION]  TAB [F] MENU 2  [B] SONG CREATOR  TAB [E] REC MODE

3 Determine the settings for recording.

[1 ]–

[3 ]

REC START

(Punch In)

Determines the Punch In timing.

NORMAL: Overwrite recording starts when the Song playback is started

via the SONG [

K] (PLAY/PAUSE) button or when you play the key-

board in the Synchro Standby mode.

FIRST KEY ON: The Song plays back normally, then starts overwrite

recording as soon as you play the keyboard.

PUNCH IN AT: The Song plays back normally up to the beginning of the

indicated Punch In measure, then starts overwrite recording at that

point. You can set the Punch In measure by pressing the [3 ] but-

ton.

[4 ]–

[6 ]

REC END

(Punch Out)

Determines the Punch Out timing.

REPLACE ALL: This deletes all data after the point at which recording is

stopped.

PUNCH OUT: The Song position at which recording is stopped is regarded

as the Punch Out point. This setting maintains all data after the point at

which recording is stopped.

PUNCH OUT AT: Actual overwrite recording continues until the begin-

ning of the specified Punch Out measure (set with the corresponding

display button), at which point recording stops and normal playback

continues. This setting maintains all data after the point at which

recording is stopped. You can set the Punch Out measure by pressing

the [6 ] buttons.

Loading ...

User Manual - Page 159