Loading ...
Loading ...
Loading ...
AGRAS MG-1P SERIES User Manual
48
© 2018 DJI All Rights Reserved.
2
Left pump calibration
Pour between 1 and 5 L of water into the spray tank, measuring the volume of water precisely
using the measuring cup.
In the app, input the volume of the water your have poured into the tank. Be sure to input
the precise value to avoid calibration bias. Tap Start Calibration and the aircraft will spray
automatically, then when ready the app will indicate that the aircraft is ready for right pump
calibration.
3
Right pump calibration
Repeat the procedure described above for right pump calibration. Once the app indicates
that right pump calibration is complete, wait for a few more moments until the app indicates
that the spraying system calibration procedure is totally complete.
3. Discharge any bubbles in the hoses using the same procedure as used when preparing for
calibration.
During calibration, tap > to cancel. The accuracy of the ow meter will be the data
before calibration.
When to Recalibrate
1. Installing a different nozzle model. Note: choose the corresponding model in the DJI MG app
after replacing nozzles. Go to Operation View >
> for conguration.
2. Using a liquid of a different viscosity.
3. The error between the actual value and the theoretical value of the completed area is more than
15%.
Starting and Stopping the Motors
Starting the Motors
The Combination Stick Command (CSC) listed below is used to start and stop the motors. Ensure
you perform the CSC in one continuous motion. The motors will begin to accelerate to an idle
speed. Release both sticks simultaneously. Take off immediately after the motors are spinning, or
else the aircraft may lose balance, drift, or even takeoff by itself and risk damage or harm.
OR
Stopping the Motors
There are two methods to stop the motors.
1. When the aircraft has landed, push the throttle down and hold. The motors will stop after three
seconds.
Throttle Stick (left stick in Mode 2)
Loading ...
Loading ...
Loading ...